Service 05 of 06
Well Integrity & Reliability
Failures that repeat are engineering problems. We design barriers that hold, investigate the ones that didn’t, and set up the integrity management that keeps an asset base out of the incident log.
When operators call us
The problems this solves.
- Sustained casing pressure or annular communication on producing wells
- Repeat equipment failures with no agreed root cause
- An asset acquisition where well integrity needs to be assessed before close
- A regulator or partner asking for integrity documentation that doesn’t exist yet
Scope
What the work covers.
Barrier design & verification
Two-barrier philosophy applied to each phase of the well, with the acceptance criteria to prove it.
Failure & root-cause analysis
Structured investigation of equipment and well failures, ending in corrective actions — not just a report.
Integrity management
Well-integrity programs: categorization, test frequencies, and escalation rules for the whole asset base.
Asset reviews
Integrity assessment of acquired or legacy wells, with remediation priorities and cost.
Deliverables
What you get.
Every engagement ends in documents your team can run with, review, and file — not a slide deck. Scope is agreed in writing before work starts.
Typical deliverables
- Barrier diagrams and verification criteria
- Root-cause analysis reports with corrective actions
- Well-integrity management program
- Asset integrity review and remediation plan
Exact scope is set per engagement. How an engagement runs →
Equipment to match
Engineered, then supplied.
The hardware this work usually calls for — specified by the same engineers who designed the program, and sourced through our supply network.
Start a conversation
Tell us about the well.
An engineer reads every request and replies within one business day.